HT - Factory Reset

Perform the steps below to restore the Urbn to their factory defaults. This may be useful for troubleshooting, or for clearing all stored pairing information for security.

  1. Make sure the Urbn are powered on and in Standby mode. In Standby mode, the Urbn can be connected to a device, but should not be playing audio.
  2. Hold down both sides of the Volume rocker switch at the same time for 8 seconds. The blue and red LEDs should blink twice simultaneously.
  3. Power the Urbn off, then on again. They will enter pairing mode automatically.

Comments

0 comments

Please sign in to leave a comment.

Powered by Zendesk